Using The Neptune Sound Processor; Powering The Neptune Sound Processor; Understanding Neptune Leds - Advanced Bionics NEPTUNE Manual De Uso

Using the Neptune Sound Processor

The Neptune System contains small parts that may cause choking if swallowed.
If the sound processor becomes unusually hot or warm, discontinue use
immediately and contact Advanced Bionics or your clinician.

Powering the Neptune sound processor

The 'on/off' button is located on the side of the Neptune sound processor. To power
on the device, press and hold the 'on/off' button for 1-2 seconds. You should notice
the orange LED within the button fl ash to indicate battery charge.
If you begin use of the sound processor with the Neptune Connect detached, the
sound processor will always activate the most recently-used program, volume,
and sensitivity settings. To reset program settings without attaching the Neptune
Connect, upon start-up press and hold the 'on/off' button for 3-5 seconds. The
processor will start up in program position 1 and reset the volume and sensitivity
settings to their default levels.
To power down the Neptune sound processor, depress the 'on/off' button for 1-2
seconds. The orange LED will fade out to indicate that the processor is powering
down.

Understanding Neptune LEDs

The LED is a programmable feature providing visual information about system
status, battery life, program position, and sound processor error conditions.
16 User Guide for the Neptune™ Sound Processor