Bonding Instructions - Speck Badu Jet IMPERIAL Manual De Instalación

Bonding Instructions

1. Glue the bonding adapter (part# 119) to the port on the
lower right side of the jet housing (See Figure 15).
2. Insert the bare end of the 8 AWG wire through the bonding
adapter and into the front of the jet housing (See Figure 16).
3. After installing the nozzle housing (part# 102.1) in Final
Assembly Section on page 17, pull the bare end of the wire
through the bonding lug on the stainless steel handles.
Tighten bonding screw (See Figure 17).
4. When installing the anti-entrapment suction cover
(part# 93) in Final Assembly Section on page 17, leave a
small length of bare wire accessible on the inside of the jet
housing (See Figure 18).
5. When installing the stainless steel cover (part# 93.1) in
Final Assembly Section on page 17, insert the bare wire into
the bonding lug on the stainless steel cover. Tighten the
bonding lug (See Figure 19).
6. Please continue back to Installation page
Figure 18
Bonding wire after suction housing installation
16
Figure 15
Bonding Adapter Location
Figure 16
Bonding wire inserted through jet housing
Figure 17
Connection to bonding lug on stainless steel
handles
Figure 19
Connection to bonding lug on stainless steel
cover