Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Step 4: Mark the boreholes with a pen or a suitable tool.
Step 5: Drill the holes.
Step 6: Hold the clamp rings in the desired position and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
Warning:
Do not connect directly with mains!
Direct power connection will destroy product.
Always connect to an appropriate controller.
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the lamp. Maintenance and service operations are
only to be carried out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
Dimensions (LxWxH):
Weight:
Fitting lamp:
Maximum ambient temperature t
Maximum housing temperature t
Please note: Every information is subject to change without prior notice. 10/00 ©
DANGER TO LIFE!
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
:
a
(steady state):
B
230 V AC, 50 Hz ~
25 W
150 cm x 5 cm
1 kg
4 x BUB0641
45° C
62° C
10
Publicidad
Tabla de contenido
