Nexgrill UNIVERSAL PARTS 710-0007 Manual De Instalación página 11

FOR MISSING PARTS, PLEASE CALL CUSTOMER SERVICE AT 1-800-913-8999
Step 7.
Figure 1 shows valve stem and bezel with the control knob
removed. Take six large stop plates from the component card
and place them over the valve stems as illustrated (Figure 2).
Take the small stop plate from the component card and place
it over the smoker and rotisserie burner valve stem (Figure 3).
Verify the tab and the stamped letter on the stop plates face
out. Replace control knobs when finished.
WARNING:
!
It is our recommendation to do not remove the
control panel in order to access the valve tips. If you choose
to remove the control panel, you must replace the control
panel bezels exactly as illustrated in Figure 2. Failure to
replace the bezels as illustrated could lead to personal
injury and/or property damage.
Step 8.
Carefully replace each burner, making sure the burner
openings slide over the gas valve nozzles. Using a screwdriver,
secure each burner to the firebox using the screws that were
set aside in Step 4. Carefully re-install the side burner and
secure with the cotter pin set aside in Step
Step 9.
Re-install the flame tamers, cooking grates, and warming
rack following the instructions contained in the Owner's
Manual for your grill. See Illustration-8.
Note:
Before using the grill, please follow instructions in the
leak testing section of this manual.
INSTALLATION INSTRUCTIONS
4.
Figure 1
Tab
Illustration-8
11
Tab
Stop Plate
Stop Pin
Figure 2
Stop Plate
Stop Pin
Figure 3
Warming Rack
Cooking Grates
Heat Shields