Nexgrill UNIVERSAL PARTS 710-0007 Manual De Instalación página 20

FOR MISSING PARTS, PLEASE CALL CUSTOMER SERVICE AT 1-800-913-8999
Step 7.
Figure 1 shows valve stem and bezel after the control knob has
been removed. Take five large stop plates from the component
card and position them over the valve stems as shown (Figure 2).
Take the small stop plate from the component pack
and position over the burner valve stems of the rotisserie and
Smoker (Figure 3). Make sure the tab and the stamped letter on
The stop plates are face outward. Attach control knobs when
complete.
!
WARNING:
It is our recommendation to not remove the
control panel in order to gain access to the valve tips. If you
decide to remove the control panel, you must replace the
control panel bezels exactly as shown in Figure 2. Not
replacing the bezels as shown could result in personal
injury and/or property damage.
Step 8.
Carefully replace each burner, making sure the burner openings
slide over the gas valve nozzles. Using a screwdriver, secure each
burner to the firebox using the screws that were set aside in
Step 4. Carefully re-install the side burner and secure with the
screws set aside in Step 2.
Step 9.
Re-install the flame tamers, cooking grates, and warming rack
following the instructions contained in the Owner's Manual
for your grill. See Illustration-7.
INSTALLATION INSTRUCTIONS
Figure-1
Tab
Illustration-7
20
Tab
Stop Plate
Stop Pin
Figure-2
Stop Plate
Stop Pin
Figure-3
Cooking Grates
Heat Shields
Warming Rack