Nexgrill UNIVERSAL PARTS 710-0007 Manual De Instalación página 8

FOR MISSING PARTS, PLEASE CALL CUSTOMER SERVICE AT 1-800-913-8999
Step 7.
Figure 1 shows valve stem and bezel with the control knob
removed. Take six large stop plates from the component card
and place them over the valve stems as illustrated (Figure 2).
Assure that the tab and the stamped letter on the stop
plates face out. Replace the control knobs when finished.
WARNING:
!
It is our recommendation that you do not remove the
control panel in order to access the valve tips. If you choose
to remove the control panel, you must replace the control
panel bezels exactly as illustrated in Figure 2. Failure to
replace the bezels as illustrated could lead to personal injury
and/or property damage.
Step 8.
Carefully replace each burner, making sure the burner
openings slide over the gas valve nozzles. Using a screwdriver,
secure each burner to the firebox using the screws that were
set aside in Step 4. Carefully re-install the side burner and
secure with the cotter pin set aside in Step -4.
Step 9.
Re-install the heat shields, cooking grates, and warming
rack following the instructions contained in the Owner's
Manual for your grill. See Illustration-8.
INSTALLATION INSTRUCTIONS
Figure 1
Illustration-8
8
Stop Plate
Tab
Stop Pin
Figure 2
Warming Rack
Cooking Grates
Heat Shields