Publicidad
Cularis KIT
Examine your kit carefully!
MULTIPLEX model kits are subject to constant quality checks throughout the production process, and we sincerely hope that
you are completely satisfied with the contents of your kit. However, we would ask you to check all the parts before you start
construction, as we cannot exchange components which you have already worked on. If you find any part is not acceptable
for any reason, we will readily correct or exchange it. Just send the component to our Model Department. Please be sure to
include the purchase receipt and a brief description of the fault.
We are constantly working on improving our models, and for this reason we must reserve the right to change the kit contents in
terms of shape or dimensions of parts, technology, materials and fittings, without prior notification. Please understand that we
cannot entertain claims against us if the kit contents do not agree in every respect with the instructions and the illustrations.
Caution!
Radio-controlled models, and especially model aircraft, are by no means playthings. Building and operating them
safely requires a certain level of technical competence and manual skill, together with discipline and a responsible
attitude at the flying field. Errors and carelessness in building and flying the model can result in serious personal inju-
ry and damage to property. Since we, as manufacturers, have no control over the construction, maintenance and ope-
ration of our products, we are obliged to take this opportunity to point out these hazards and to emphasise your per-
sonal responsibility.
Warning:
Like any other aircraft, this model has static limits! Steep dives and silly, imprudent manoeuvres may cause structural
failure and the loss of the model. Please note: damage caused by incompetent flying is obvious to us, and we are not
prepared to replace components damaged in this way. It is always best to fly gently at first, and to work gradually to-
wards the model's limits.
Adhesives: cyano-acrylate ("cyano") and activator
Use high-viscosity cyano-acrylate glue ("thick cyano" - not styrofoam cyano) in conjunction with activator ("cyano kicker"). Epoxy
adhesives produce what initially appears to be a sound joint, but the bond is only superficial, and the hard resin breaks away
from the parts under load.
Hot-melt glue (from a glue gun) is a useful alternative adhesive.
MULTIPLEX radio control system components for the Cularis
Micro IPD UNI receiver
alternatively
or
RX-7 SYNTH IPD receiver
alternatively
Tiny-S UNI servo (2 required)
Nano-S UNI servo (4 required)
Cularis cable set
Contents:
2 x 600 mm UNI extension lead
1 x 400 mm UNI extension lead
Mini switch harness with charge socket
Battery charger:
MULTIcharger LN 5014 (charge current 100 mA ... 5A) 1 - 14 cells NiCd / NiMH
and 1 - 5 Lithium-Polymer cells
Cularis power set
Contents: Himax 3522-0700 motor
MULTIcont BL-37 speed controller
Propeller driver and spinner
12 x 6" propeller
12
# 21 4218
35 MHz, e.g. A-band
40 MHz
35 MHz, e.g. A-band
40 MHz
Elevator / rudder
2 x ailerons
(Order No. 8 5032)
(Order No. 8 5029)
(Order No. 8 5045)
Order No. 5 5971
Order No. 5 5972
Order No. 5 5880
Order No. 5 5882
Order No. 6 5121
Order No. 6 5120
Order No. 8 5055
Order No. 9 2531
Order No. 33 2633
Publicidad
