Important - Maytag MED5620TQ0 Manual De Uso Y Cuidado

4-wire connection: Power Supply Cord
IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do
not permit the use of 3-wire connections.
B
c D
F
E G
2.
A. 4-wire receptacle" (NEMA type 14-30R)
B. 4-prong plug
C. Ground proI1g
D. Neutral prong
E.Spade terrninal_ with upturned ends
F. %" (t.9 cm; Ut li_te'd strain re'lief
G. Ring terminals
Remove center silver-colored terminal block screw.
Remove neutral ground wire from external ground conductor screw. Connect neutral
ground wire and the neutral wire (white or center wire) of power supply cord under
center, silver-colored terminal block screw. Tighten screw.
A B C
r
?
3_
Connect ground wire !green or bare) of power supply cord to external ground conductor
screw. Tighten screw.
B C
4,
5.
6.
7,
F
D
A. Fxternal ground conductor scre'w
B. O'nter silver-colored terminal block scre'w
C. Neutral wire' fwhite or center wire)
D. ?4" (1.9 crn) U[ Ibted strain relief
E. Ground wire (gre'en or bare) of power supply cord
t_ Neutral ground wire
Connect the other wires to outer terminal block screws. Tighten screws.
Tighten strain relief screws.
Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
You have completed your electrical connections. Now go to "Venting Requirements."
D
A. fxternal ground conductor screw - Dotte'd line shows
position of NEUTRAL ground wire before being moved to
cente'r silver-colored ten'ninal block screw.
B. C_'nte'r silver-colored terminal block screw
C. Neutral wire" (white or center wire')
D. 74" (1.9 cm) UL li_te'd strain re'lief
E. Neutral ground wire"
10