Residual Risks; Safety Instructions - Mafell KF 1000 Manual De Instrucciones Original

Any other use than described above is not permissible. The manufacturer cannot be held liable for any damage
arising from such other use.
In order to use the machine as intended, comply with the operating, maintenance, and repair instructions
specified by Mafell.
Please take into account the milling motor capacity at maximum tool diameter and anticipated machining
depth.
Keep power tools away from rain or moisture. The penetration of water into a power tool increases the risk of
electric shock.
The appliance is not designed for non-stop industrial operation. The maximum speed can be referenced in
chapter 2.3 Technical data.

2.7 Residual risks

- Breakage of the tools and risk of the tools or parts of them being hurled away.
- Touching live parts with the housing open and the mains plug not removed.
- Hearing can be impaired when working for long periods without ear protectors.
- Emission of hazardous or potentially explosive dusts (all types) during longer lasting operation without
extraction. Please note the safety data sheet of the material to be machined.
3

Safety instructions

General instructions:
- Children and adolescents must not operate this machine. This rule does not apply to young persons
receiving training and being supervised by an expert.
- Never work without the protection devices stipulated for the respective operating sequence and do not effect
any modifications on the machine that could impair safety.
- Damaged cables or plugs must be immediately replaced. Replacement may only be carried out by Mafell or
an authorised MAFELL service workshop in order to avoid safety hazards.
- Avoid sharp bends in the cable. Do not wind the cable around the power tool especially when transporting
and storing the power tool.
Machine-specific safety instructions:
- Only hold the power tool by the isolated handles, as the milling tool could encounter and cut into its
own connecting cable. Cutting accessory contacting a "live" wire may make exposed metal parts of the
power tool "live" and could give the operator an electric shock.
- Only operate the machine with a correctly fitted milling table and extraction hood.
- Only use milling tools approved for at least 25,000 rpm according to EN 847.
Danger
Even if used in accordance with its intended purpose and despite conforming with the
safety instructions, residual risks caused by the intended use will always remain.
Danger
Always observe the following safety instructions and the safety regulations applicable
in the respective country of use!
-17-