Residual Risks; Setup / Adjustment; Mains Connection; Routing Of The Connecting Cable - Mafell LS103Ec Instrucciones De Funcionamiento Y Seguridad

LS103Ec

3.6 Residual risks

The existing residual risks include:
- Touching the cutting chain in the open section.
- Touching the cutting chain above the workpiece during the mortising process.
- Touching the part of the cutting chain protruding below the workpiece when you are mortising through the
workpiece.
- Touching the cutting chain from the side.
- Breaking cutting chain.
- Backlash of the machine against the user if the transverse guide fence is not fixed during freehand milling.
- Impaired hearing when working without hearing protection for long periods of time.
- Emission of harmful wood dusts during longer operation without extraction.
4

Setup / adjustment

4.1 Mains connection

Prior to starting up the machine, check to ensure that the mains voltage corresponds to the operating voltage
specified on the rating plate of the machine.

4.2 Routing of the connecting cable

02/2022
Warning
Risk of injury when working with the machine
Even when the machine is used as intended and in compliance with the safety
regulations, there are still residual risks caused by the intended use, which can
have consequences for your health.
Observe the safety instructions and information in these instructions.
➢
Always be extremely careful and cautious when you work with the machine.
➢
Warning
Electric shock when cutting into the connecting cable
The connecting cable can impair safety functions and work functions and
get into contact with the cutting tool. Cutting into the connecting cable of
the machine puts the metal parts of the machine under tension and
causes an electric shock. There is a risk of injury for the user.
When working, pay attention to the way the connecting cable is
➢
routed.
Never cut into the connecting cable of your machine.
➢
11