Bosch SGH182-01 Instrucciones De Funcionamiento Y Seguridad página 9

to tool, slide collated screw strip through the
strip guide on the auto-feed attachment (Fig. 2).
2. To avoid jamming screws into auto-feed
attachment, carefully slide collated screw strip
through the guide strip until first screw is
engaged in the self-feeding mechanism (Fig. 2).
3. An engaged screw strip must exit through the
top of the self-feeding mechanism.
This tool is intended for driving and removing
screws. It is not suited for high-torque
applications such as driving TEK® screws.
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed (Fig. 1).
"LOCK-ON" BUTTON
The "Lock-ON" button, located below the
trigger allows for continuous operation at
maximum RPM without holding the trigger.
TO LOCK TRIGGER "ON": squeeze trigger,
push up on Lock-On button, and release
trigger (Fig. 8).
TO UNLOCK THE TRIGGER: squeeze trigger
and release it without depressing the "Lock-
ON" button.
If the "Lock-ON" button is
continuously being de-
WARNING
pressed, the trigger can not be released.
1
2
FIG. 8
Any attempt to pull screw strip through the
bottom of the self-feeding mechanism may
damage the auto-feed attachment. To remove
screw strip, pull strip from the top of the self-
feeding mechanism.
Operating Instructions
This tool is equipped with a clutch that, when
combined with the Posi-Lok™ depth control,
stops the screw at the desired depth and
prevents the screw head from becoming
stripped or breaking the bit tip.
The clutch becomes engaged and begins
driving the screw into the work piece when
pressure is placed on the bit tip. The clutch
becomes disengaged and stops driving the
screw when the depth control contacts the
work piece and releases the pressure on the
bit tip.
This control can be accessed on either side of
the tool to change the direction of rotation of the
bit.
Forward clockwise rotation:
Reverse counterclockwise rotation:
to a complete stop. Shifting during rotation of
the chuck can cause damage to the tool.
-9-
After screw strip is installed,
do not pull strip backwards.
CAUTION
PRESSURE CONTROLLED CLUTCH
ROTATION DIRECTION SWITCH
FIG. 9a
Move the rotational direction switch to the
forward position (Fig 9a).
Move the rotational direction switch to the
reverse position (Fig. 9b).
Do not change direction of
rotation until the tool comes
CAUTION
FIG. 9b