Handling Instructions; Packaging Removal; Pre-Installation Instructions - John Bean EHP System IV-E Manual Del Operador

10.3 HANDlING INSTRUCTIONS

ALWAYS WEAR GLOVES WHEN UNCRATING
THE MACHINE TO PREVENT SCRATCHES OR
ABRASIONS DUE TO CONTACT WITH PACKING
MATERIALS.
The shipping box is mounted in a steady wooden pal-
let. The machine should be transported only with an
appropriate lifting device (fork lift) Fig.1.
Uncrating: Pay attention when cutting the banding or
during any other operation which may be hazardous.
After removing the shipping box check for any visible
damage to the machine and its components, notify the
carrier immediately of any damage.
For installation assistance call your JBC Represen-
tative.
Figure 1.

10.4 PACKAGING REMOVAl

The material of the packing (plastic bags, polystyrene,
nails, screws, wood etc.) shall not be left behind and
shall not be left at children reach since they may be
possible hazards.
Place the above mentioned materials in proper trash
container and dispose following any local regulations.
10.5 PRE-INSTAllATION AND IN-
STAllATION INSTRUCTIONS.
Refer to MH 310-320 PRO User Manual.
EN-27