Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3 SEC.
The capacitive menu selection button may not work if touched using objects or when wear-
ing gloves, therefore always operate it using a bare finger.
7.2) SELECTION SCREENS:
of the tool, can be changed by operating the touch button:
Enabling/disabling the LED Worklights
LED
ON
LED
OFF
Return to original factory settings / firmware version
When the "RESET" screen is displayed, return the tool to its factory setting by operating the touch
button for at least 3 seconds; a beep will confirm the setting.
RESET
The RESET screen also shows the firmware version of the circuit board.
SW:S1J41AH
7.3) WARNINGS:
these appear during operation and notify the operator of the status of the tool:
BATTERY
BATTERY
13001
15
To make a selected screen operational and appear at each start-up of the
tool, operate the touch button for at least 3 seconds; a continuous beep
will confirm the setting.
control parameters that cannot be set as automatic upon start-up
3 SEC.
LOW BATTERY: replace the battery.
NOTE: when the battery Vage falls below a minimum safety threshold, the tool
will not start; although it is still possible to end the work cycle in progress.
BATTERY TEMPERATURE HIGH: remove the battery and wait until it cools down.
NO. OF CYCLES TO MAINTENANCE REACHED:
the tool continues to work however, it is recommended that it is sent to
Cembre for a complete overhaul (see § 8).
NOTE: this message, together with a beep, will reappear when the tool has
been idle for 30 seconds.
(factory setting LED ON)
LED
OFF
LED
ON
When the screen is displayed,
touch the button for at least
3 seconds to deactivate or
reactivate operation of the LED
Worklights during tool use; a
continuous beep will confirm
the setting.
Publicidad
Tabla de contenido
