Battery Status; Thorough Cleaning - Cembre B500 Manual De Uso Y Mantenimiento

Ocultar thumbs Ver también para B500:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

2.8) Battery status

BATTERY 
The battery is equipped with LED indicators that indicate the remaining battery life at
any time by pressing the adjacent button (P) (Ref. to Fig. 5):
4 LEDs illuminated: fully charged
BATTERY
2 LEDs illuminated: 50 % capacity
1 LED flashing: minimum charge, replace the battery.
With the battery inserted into the tool, the remaining
battery life can also be checked on the display, via
touch button selection (Ref. to § 4).
The screen shown alongside indicates that the battery Valtage
RESET
has dropped below a minimum safety threshold; under these
SW:S1J41AH
conditions the tool will not start, and it is necessary to recharge or replace
the battery.
The approximate time to fully recharge a battery is about 80 minutes.
LED
After each working cycle, and after the extraction of the battery from the tool, an
OFF
integrated battery cut-off device will operate after 70 s approx.
Then the LED nearest to button (P) will flash 5 times each 14 s approx. The battery will
n
LED
be reactivated when it is reintroduced into the tool and the operating button is pressed.
n
ON
2.9) Using the battery charger
Carefully follow the instructions in the battery charger user manual.
3. MAINTENANCE
i
i
The tool is robust, completely sealed, and requires very little daily maintenance. Compli-
ance with the following points, should help to maintain its optimum performance:

3.1) Thorough cleaning

Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any
residue, especially close to pivots and moveable parts.
Do not use hydrocarbons to clean the rubber parts.
3.2) Storage case
When not in use, the tool should be stored and transported in the plastic case, to prevent
damage. The case, type VAL P35, is suitable for storing the tool, the accessories and up to
20 die sets and pre-prepared compression connectors.
VAL P35: Size 500x480x128 mm (19.7x18.9x5.0 inches). Weight 3,1 kg (6.8 lbs).
9
All manuals and user guides at all-guides.com
F
= 60.0 kN
m
Fp = 24.5 kN
20001
F
= 6.75 ton
m
Fp = 2.75 ton
F
= 60.0 kN
m
P
= 661 bar
m
F
= 58.3 kN
p
Pp = 312 bar
P
= 661 bar
m
P
= 485 bar
P
p
= 9587 psi
m
Pp = 4525 psi
max.
BATTERY
BATTERY
1000
-19000
B500
LED
NR 13AJ002
ON
LED
OFF
3 SEC.
F
m
F
p
ERROR
P
m
P
= 485 bar
p
001
002
003
F
= 60.0 kN
m
OK
004
P
= 661 bar
m
OK
min.
BATTERY
= 60.0 kN
F
m
= 58.3 kN
= 661 bar
P
m
max.
BATTERY
BATTERY
BATTERY 
BATTERY
LED
ON
LED
OFF
RESET
SW:S1J41AH
LED
OFF
LED
ON
= 60.0 kN
OK
= 661 bar
OK
min.
20001

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

B500aB500eB500t

Tabla de contenido