Corghi ProLine 650 Manual De Uso página 47

Fitting the external sensor and
relative support (if available)
- Fix the external sensor support to the whe-
el balancer body using the three screws
supplied with the machine (A, Fig.5c);
- Insert the external sensor pin (b, Fig.5c)
in the sensor support bush (C, Fig. 5c);
- Screw the screw (D, Fig. 5c) bringing it
closer to the sensor pin without touching
it;
- Make sure that the external sensor rotates
freely;
- Connect one of the sensor's cable connec-
tors to the socket located on the sensor
body (H, Fig. 5b);
User manual ProLine 650
5
5a
- Tape the cable to the sensor support (F,
Fig. 5c) so that it is never tensioned;
- Connect the sensor cable connector to the
machine rear panel (G, Fig.5c).
IMPORTANT: after installing the external
sensor, calibrate the sensor as described
in the paragraph "Width sensor calibra-
tion".
Applying adhesive plates
Ensure the surfaces are dry, clean and
free of dust before applying the adhesive
plates.
Refer to the instructions in the personali-
sation kit for applying the machine name
adhesive plate to the casing or optional
personalisation panel.
Apply the machine data plate (2) in the
5b
5c
UK
47