Fitting Instructions - Brevi Tao b.fix Instrucciones De Uso

we suggest that you NEVER use or purchase a
second hand child car seat.
Checking the Car's Seat Belts
WARNING: The TAO 1,2, 3 b.fix child car seat
must ONLY be installed facing forward, on the
front or back seat of the vehicle and ALWAYS
secured using the three-point safety harness (1)
(2) with inertia reel (Pic. 2).
Checking the position of the vehicle's seat
belt buckle
The stability of the child car seat may be com-
promised by the position of the vehicle's seat belt
buckle. If the seat belt buckle is as illustrated at
the top of Fig. 3, the child car seat is not suitable
for use in this vehicle or at least, on this seat.
Field of application
_ For use with child car seat harnesses. From 9 to
18 kg (age group: approx. 9 months to 4 years)
_ For use with the car's seat belt. From 15 to 36 kg
(age group: approx. 3 months to 11 years)

FITTING INSTRUCTIONS

Warnings
Only use the child car seat to transport the child in
the vehicle. Place the child car seat on the appro-
priate seat in the vehicle, facing forward. Ensure
that the backrest of the vehicle's seat, if adjusta-
ble, is locked in the upright position. Make sure
the vehicle's seat is set to the fully back position.
Always respect road and traffic laws in your
country of residence.
32
Using supplementary Isofix connectors
The Isofix connectors must be used to ensure
greater stability of the child car seat.
TAO 1, 2, 3 b.fix is equipped with plastic runners
(that you can use if your vehicle does not have
them) to facilitate insertion of the Isofix connec-
tors in the correct position, in correspondence
with the anchoring points of the vehicle's seat.
1. Secure the plastic runners on the anchoring
points (Pic. 6 and 7)
2. Simultaneously insert both of the child car se-
at's Isofix connectors into the runners (Pic. 8).
3. Snap both connectors into the Isofix anchoring
points (Pic. 9).
4. Important: verify that both connectors have
been correctly fastened to the anchoring points.
You should hear two distinct "clicks".
5. If the safety indicators (1) located on the sides
of the Isofix connector unit are green, the two
connectors have been correctly fastened.
6. To properly complete the installation process,
use the car's seat belts in accordance with the
instructions provided in this book and based on
your child's weight.
Releasing the Isofix connectors
To release the Isofix connectors from the seat's
anchoring points, pull the two release devices (2)
as shown in Picture 10.
SECURING THE CHILD CAR SEAT - FROM 9
TO 18 KG (approx. 9 months to 4 years)