Din Rear-Mount - Pioneer DEH-1150MPG Manual De Instrucciones

Section
Installation
04

DIN Rear-mount

1 Extend top and bottom of the trim ring
outwards to remove the trim ring. (When
reattaching the trim ring, point the side
with a groove downwards and attach it.)
! It becomes easy to remove the trim ring if
the front panel is released.
2 Determine the appropriate position
where the holes on the bracket and the
side of the unit match.
3 Tighten two screws on each side.
Screw
Mounting bracket
! Use either truss screws (5 mm × 8 mm) or
flush surface screws (5 mm × 9 mm), de-
pending on the shape of screw holes in the
bracket.
16
En
Trim ring
Dashboard or console
Black plate (16,1)
QRD3017-A/N
< >16