Cleaning The Blender; Storage; Troubleshooting - Bosch MCM64080 Instrucciones De Uso

Cleaning the blender

Risk of injury from sharp blades!
Do not touch blender blades with bare
hands. Clean them with a brush.
It is recommended to clean the blender
immediately after use. This will prevent
residue from drying on and attacking the
plastic (e.g. by essential oils in herbs).
The blender jug, lid and funnel are
dishwasher-proof.
Do not clean blade insert in the dishwasher,
but under running water.
Do not leave in water!
Tip: Pour a little water and washing-up liquid
into the attached blender. Switch to setting M
for several seconds. Pour out the water and
rinse the blender with clean water.
Taking the blender apart
Fig.

Upon the wings, rotate the blade insert

in an anti-clockwise direction.
The blade insert is released.
Take blade insert out and remove sealing

ring.
Putting the blender together
Apply sealing ring on blade insert.

Insert blade insert from below into

blender jug.
Firmly screw on the blade insert

by the wings in a clockwise direction.
Rotate the blade insert at least until
a wing covers the mark on the blender
jug (position –> Fig.

Storage

Risk of injury!
When the appliance is not in use, pull out
the mains plug.
cáÖK=
Store tools and cutting discs in the acces-

sories bag.
Always store the universal blade with
the blade guard attached.
Stow the cable by pushing it carefully

into the cord store.
Robert Bosch Hausgeräte GmbH
-6).


Troubleshooting

Risk of injury!
Before rectifying a fault, pull out the mains
plug.
Important information
The Operating indicator flashes
if the appliance has been operated
incorrectly or the electronic fuse has
tripped or the appliance is defective.
Base unit
Fault:
Appliance does not work.
Possible cause:
The appliance was overloaded (e.g. tool
jammed by food) and the electronic fuse
has tripped.
Remedial action:
Set the rotary switch to 0/off.

Remove mains plug.

Eliminate the cause of the overload.

Switch the appliance on again.

Possible cause:
An attempt was made to attach the bowl
or blender to the appliance while
switched on.
Remedial action:
Set the rotary switch to 0/off.

Attach the bowl or blender.

Switch the appliance on again.

Bowl/lid/accessories
Fault:
Appliance does not start.
Possible cause:
Parts not correctly attached.
Remedial action:
Set the rotary switch to 0/off.

Attach parts according to the appropriate

instructions in this manual.
Important information
If the fault cannot be eliminated,
please contact customer service
(see customer service addresses
at the end of this booklet).
en
21