Cleaning And Servicing; Cleaning The Motor Block; Cleaning The Blender - Bosch MMB66G3M Instrucciones De Uso

Fig. D
■ Put down universal cutter jug with the
opening face up.
■ Add food, which is to be cut, in the
universal cutter.
■ Place seal on the blade holder. Ensure
that the seal is positioned correctly.
Important information
If the seal is damaged or not correctly posi-
tioned, liquid may run out.
■ Grip blade holder by the handle and
insert into the universal cutter jug.
Note shape of the parts (Fig. D-2)!
■ Move handle (Fig. D-3). This locks the
blade holder in the universal cutter jug.
■ Turn universal cutter jug over.
■ Place universal cutter jug on the drive
on the motor block. Arrow on the univer-
sal cutter jug points towards the dot on
the motor block.
■ Attach universal cutter jug by turning it
all the way clockwise.
■ Switch on the appliance: set the rotary
switch to on.
■ Turn rotary switch to Q and hold.
or
■ Press quick selection button V
(depending on model).
Note: The longer the appliance remains
switched on, the finer the ingredients are
cut. In the case of herbs the required cutting
result can be achieved very quickly after
switching the appliance on.
After using the appliance
■ Set the rotary switch to 0/off.
■ Remove mains plug.
■ Remove universal cutter jug by turning
it anti-clockwise.
■ Turn universal cutter jug over.
■ Remove blade holder. To do this, fold
the handle upwards and pull out the
blade holder.
■ Empty universal cutter jug.
■ Remove the rest of the chopped food
from the jug using a suitable implement
(e.g. spoon).
■ Clean all parts, see "Cleaning and
servicing".
Cleaning and servicing

Cleaning and servicing

The appliance requires no maintenance!
Thorough cleaning guarantees a long
service life. An overview of cleaning the
individual parts can be found in Fig. E.
W Risk of electric shock!
Never immerse the motor block in water
and never hold under running water and do
not clean in the dishwasher.
Warning!
Do not use abrasive cleaning agents.
S urfaces may be damaged.
Tips:
– Preferably clean the parts immediately
after use. This will prevent residue from
drying on and attacking the plastic
(e.g. by essential oils in herbs).
– If processing e.g. carrots and red
cabbage, the plastic parts will become
discoloured by a red film which can be
removed with a few drops of cooking oil.

Cleaning the motor block

■ Remove mains plug.
■ Wipe motor block with a damp cloth. If
required, use a little detergent.
■ Then wipe dry.
Cleaning blade holder
W Risk of injury from sharp blades!
Do not touch blender blades with bare
hands. Clean them with a brush.
Do not clean blade holder in the dish-
washer, but under running water using
a brush. Do not leave in water! Remove
seal for cleaning.

Cleaning the blender

The blender jug, smoothie insert, lid and
measuring cup are dishwasher-safe.
Tip: Pour a little water and washing-up liquid
into the attached blender. Switch to setting
Q for several seconds. Pour out the
water and rinse the blender with clean water.
Cleaning the universal cutter
The universal cutter jug is not
dishwasher-safe.
en
19