Functional Testing Of The End Positions; Emergency Manual Manoeuvre; Assembly Of The Crank Handle; Using The Crank Handle - Nice ERA XL Instrucciones Y Advertencias Para La Instalación Y El Uso

5.5 - Functional testing of the end positions

Allow the drive to run to the 'up' and 'down' end positions
again and check the end positions. Carry out a fine adjust-
ment if necessary.
6

EMERGENCY MANUAL MANOEUVRE

• Switch off the circuit breaker (main switch) before manual
operation.
• The manual operation is only needie for operating the
door, awning, roller shutter etc. in an emergency, e.g. in
the case of power failure.
• Operation of ERA XLH drives with a drill etc. is forbidden.
• Keep the crank handle in the immediate vicinity of the
door so that it is easily accessible at all times.
• No more travel commands must be present or given.
• Manual operation may only be done with the motor
stopped and switched off.
• Manual operation may only be done from a safe position.
• Keep people away during manual operation.
• Do not move the system beyond its end positions during
manual operation.
• Make sure the shaft rotates freely when operating it man-
ually.
• Mount the crank handle at a height of no more than 1.8 m.
• The crank handle must be mounted so that it is suitable
for use at any time.
• Manual operation can only be done from a safe standing
place and with the drive switched off.
• The crank handle connection must not be subjected to
impacts.
• The crankshaft must turn freely.
• In roll-up systems, the shaft must not be subject to radial
or axial forces, and must rotate freely.

6.1 - Assembly of the crank handle

• Connect the shaft to the crank handle connection.
• Secure it axially using the locking spring.
6 – English
Crank handle
connection
Locking
spring
Bar

6.2 - Using the crank handle

• The circuit breaker (mains switch) must be switched off
before manual operation.
• Do not move the system beyond its end positions during
manual operation.
• Open or close the shutter. The motor's limit switch is dis-
abled.
• After manual operation, turn the crank handle back
about ¼ of a turn to re-enable the motor's limit switch.
The door can be operated electrically again.