Installation Of The Temperature Sensors - Zenner Zelsius C5-ISF Manual De Montaje E Instrucciones

Deutsch English
■
Use only new and flawless sealing
material and check the seal face
for damage.
■
Install the new flow sensor accor-
ding to the correct flow direction
and installation position.
■
Turn heat computer to desired
reading position.
Information: The best measuring
results can be achieved by moun-
ting with horizontal diallevel. Combi-
devices are, for example, used in
tight installation points without room
for the calculator on the flow sensor
or when the calculator is difficult to
read. Therefore the device still re-
mains easy to read enabling opti-
mum use of the space available for
installation of the flow meter.
Installation of the temperature
sensors
■
The installation of the tempera-
ture sensors should be preferably
symmetrical and direct installati-
on.
■
Do not remove the return sensor
if already mounted on the VMU.
This is also valid for all the safety
seals which are mounted on the
device as a standard.
■
Sensors
Supply
Return
Asymmetrical sensor installation for zelsius
C5-ISF with the return sensor integrated in the
measuring capsule.
24
Français
are colour-coded
Consumer
(according
red= Supply (the hot side in
„Heating" mode and the cold
side in
blue= Return (the cold side in
„Heating" mode and the hot side
in „Cooling" mode).
■
The connecting cables may not
be buckled, extended or shor-
tened.
■
The seal at the sensor installation
point on the measuring capsule
may not be damaged.
■
Remove locking screw and seal
at the ball valve completely, if
existing.
■
Attach the O-ring to the installa-
tion aid (the 2nd O-ring is only a
spare O-ring). Using the installa-
tion aid, insert the O-ring into the
installation point according to DIN
EN 1434 with a slight circular mo-
tion.
■
Using the other end of the instal-
lation aid bring the O-ring into the
correct position.
■
Insert the 2 halves of the plastic
connector into the sensor's three
notches (crimps) and press them
together.
■
Use the installation aid as positi-
oning aid.
Supply
Return
Symmetrical sensor installation for zelsius
®
C5-ISF.
to the model):
in „Cooling" mode);
Consumer
®