Norcold N180.3 Manual De Servicio página 3

All electrical connections and repairs
to the refrigerator must comply with all
applicable codes. Refer to the certification
and code requirements section of the
Installation Manual.
Turn off AC power and DC power sources
before attempting to remove, service, or
repair any of the refrigerator's electrical
or electronic components. Do not work on
live electrical circuits.
Do not modify, bypass, or eliminate any of
the refrigerator's electrical components,
electronic circuits, or propane gas system
components.
Do not wet or spray liquids on or
near electrical outlets, connections or
components. Most liquids, including
leak detection solutions, are electrically
conductive and pose the potential for an
electric shock hazard, short electrical
components, damage electronic circuits,
and/or ignite a fire.
Do not use leak test solutions that
contain ammonia or chlorine. Ammonia
and chlorine degrade copper and brass
components.
The cooling unit is a sealed system under
pressure! Do not try to repair or recharge
the cooling unit. Do not bend, drop, weld,
drill, puncture, saw, or strike the cooling
unit.
Handle a leaking cooling unit with
extreme caution! The cooling unit
contains ammonia, hydrogen, and sodium
chromate. Ammonia can cause severe
skin and eye burns. Hydrogen is highly
flammable, can ignite and burns with
an intense flame. Certain chromium
compounds, such as sodium chromate,
are carcinogenic.
Do not use extension cords. Do not
remove the grounding prong from the
refrigerator AC power cord. Do not use
a two prong adapter to connect the
refrigerator to the AC outlet.
Do not over-fuse electrical circuits. Use
specified fuses and AWG wire sizes.
The specification section of this manual
provides fuse size information. Refer to
the Installation Manual for the correct
AWG wire size specifications.
Prevent child entrapment! Before
disposing of the refrigerator, remove
all doors and fasten all shelves with
retainers.
Make sure all hardware such as hinges
and fasteners (retaining screws, etc.) are
properly fastened.
www.norcold.com
CAUTION
!
3
Obey the instructions in this manual with
regard to intake and exhaust venting
specifications.
Do not install the refrigerator directly on
carpet. Put the refrigerator on a metal or
wood panel that extends the full width and
depth of the refrigerator.
Some of the refrigerator's metal
components have sharp corners and
edges. Wear hand protection, such as cut
resistant gloves, and exercise extreme
care when handling the refrigerator.
SERVICE MANUAL