Carrera RC 370503018 Instrucciones De Montaje página 22

• Fly the model.
• The LED lamps on the model start to flash
shortly before the battery is discharged.
• Land the model.
• Switch the model off at the ON/OFF switch
• Disconnect the battery plug connection.
• Always switch off the remote control last.
Flying the 4-channel Quadrocopter
NOTE!
Take care particularly in the first few
flights to move the lever on the control-
ler very gently and not over-hurriedly. As
a rule, only very small movements of the
respective levers are necessary to carry
out the desired control commands!
If you notice that the Quadrocopter moves
forwards or to the side without your touching
the respective lever, please adjust the trim of
the Quadrocopter as described in
+/- Gas (up / down)
13
To start or to fly higher, push the gas le-
ver on the left cautiously forwards. To land
or fly lower, push the gas lever on the left
cautiously backwards.
14 To make the Quadrocopter circle to the left
or the right on the spot, move the lever on
the left cautiously to the left or the right.
15
To fly the Quadrocopter to the left or the
right, push the lever on the right cautiously
to the left or the right.
16
To fly the Quadrocopter forwards or back-
wards, push the lever on the right cautious-
ly forwards or backwards.
Start the rotors and motors
17 a Press the 'Start rotors' button on the
controller, in order to start the motors.
You can lift the throttle control upwards as
soon as the rotors are running.
ENGLISH
23
24 25 26
Looping function
WARNING!
ONLY FOR EXPERIENCED PILOTS!
17 b If you press the "Looping Button"
then an acoustic signal sounds 5x times.
As long as the acoustic signal sounds,
slide the right-hand joystick up, down, to
the right or to the left. The Quadrocop-
ter then carries out the loop or roll in the
respective direction. Before you do this,
make sure you have ample room on all
sides (about 4 m – 13').
The "3D looping" only functions when
the camera is unplugged and removed!
Beginner/Advanced switch
30% = beginner mode
17 c
Signal sounds once on switching over.
.
60% = medium mode
The quadrocopter reacts more sensitively
than in 30 % mode. Signal sounds twice
on switching over.
100% = Advanced Modus -> 3D Modus
The Quadrocopter reacts very sensitive-
ly to joystick movements. Signal sounds
three times on switching over.
WARNING!
100 % IS ONLY FOR EXPERIENCED PILOTS!
Headless Mode
17 d The headless mode helps beginners
learn how to fly. Regardless of which di-
rection the Quadrocopter is rotated, the
flight direction always corresponds exactly
to the flight direction implemented on the
controller. Therefore a beginner no longer
has to steer mirror-imaged when he flies
e.g. to himself.
If you press the "Headless Mode Button"
, an acoustic signal sounds for as long
9
as you are in the Headless mode. To de-
activate the Headless mode, press the
button renewed.
22
,
1
2