Stand-Alone; Remote Control Operation - NEO STEAM 700 Manual De Usuario

9. OPERATION

Stand-alone

Please put the Steam 700RGBA on a dry and flat
surface.
1. Plug mains power cord from the fog machine
into appropriate power supply socket.
2. Primary power on, LED display (G of figure 1)
shows "8888", and 16 LEDs (A of figure 1)around
the nozzle all light up. Please check if the LED
letters shown on the display lack of strips, and
then show the current software version.
3. 2 seconds after it switches to working status:
Heating up, it shows "HEAt". Setting function
value is allowed when heating up. With no op-
eration after 4 seconds, it goes back to "HEAt"
status.
4. Wait about 9 minutes for heating element to
heat up.
5. Push the Manual Fog button (L of figure1) to
smoke.
Manual fogging is available under any control mode
and always executing the Color Macro of CHA.

Remote Control Operation

For best result, use RC-4CA wireless controller.
1. Firmly attach the remote control to socket (O of
figure1) on the back of the unit.
2. Plug mains power cord from the fog machine
into appropriate power supply socket.
3. LED display (G of figure 1) shows "8888", and 16
LEDs (A of figure 1) around the nozzle all light
up. Please check if the LED letters shown on the
display lack of strips, and then show the current
software version.
4. 2 seconds after it switches to working status:
Heating up, it shows "HEAt". Setting function
value is allowed when heating up. With no op-
eration after 4 seconds, it goes back to "HEAt"
P. 12
Neo Steam 700 RGBA - English version
status.
5. Wait about 9 minutes for heating element to
heat up.
6. "CH.A, CH.b, CH.c, CH.d" respectively key A, B,
C, D of remote controller. Each channel can
be individually set its Color Marco by menu
button of the machine (see "SYSTEM MENU"
instruction).
7. Except "dx" and "A.xxx", under any other
status, wireless control is available while DMX
control is not available.
8. Refer to your controller manual for controller
operation details. (Appendix A )
Manual fogging could be work with remote control
operation at the same time.
When shot down, the present function status will be
saved automatically and continue when powered
on next time.
DMX Control Operation
Use LED Display to set the unit to the desired
DMX512 address. Refer to DMX channel chart in
Figure 2.
1. Connect the DMX 512 controller cable to the
input socket (M of figure 1) of the fog machine
unit. Make sure the signal cable polarity is
correct.
2. Plug mains power cord from the fog machine
into appropriate power supply socket.
3. LED display (G of figure 1) shows "8888", and
16 LEDs (A of figure 1) around the nozzle all
light up. Please check if the LED letters shown
on the display lack of strips, and then show
the current software version.
4. 2 seconds after it switches to working status:
Heating up, it shows "HEAt". Setting function
value is allowed when heating up. With no op-
eration after 4 seconds, it goes back to "HEAt"