Warranty - Dometic Waeco SinePower MSI2312T Instrucciones De Montaje

SinePower
The LED (fig. 5 2, page 4) lights up red to indicate the fault:
LED display
Quick flash
Slow flash
Occasional flash
Constantly lit
13

Warranty

The statutory warranty period applies. If the product is defective, please
contact the manufacturer's branch in your country (see the back of the
instruction manual for the addresses) or your retailer.
For repair and guarantee processing, please include the following docu-
ments when you send in the device:
 A copy of the receipt with purchasing date
 A reason for the claim or description of the fault
EN
Cause
Input voltage is too high
Input voltage too low
Overheating
Short circuit or reversed polar-
ity
Excessive load
Remedy
Check the input voltage and reduce
it.
The battery needs recharging.
Check the cables and connections.
Switch off the inverter and the con-
sumer.
Wait 5 to 10 minutes and switch the
inverter on again without any electric
consumers.
Reduce the load and make sure the
inverter has better ventilation. Then
switch the consumer back on.
Switch off the inverter and remove
the consumer.
Then switch the inverter back on
without the consumer. If no exces-
sive load is now shown, then there is
a short circuit in the consumer or the
total load was higher than the power
specified on the data sheet. The fuse
in the device must be pressed in
again by hand after it has been trig-
gered by excess current.
Check the cables and connections.
Warranty
49