Solutions to Common
Problems
DISHES NOT DRY
FOOD SOILS LEFT ON
Check incoming water temperature. (See
Getting Started, page 5.) It should be at least
120°F (49°C). (See Factors Affecting
Performance, page 15.)
Choose another cycle for longer washing
time.
•
Check rack loading section for proper
loading--avoid
nesting items.
•
Home water pressure may be too low--
should be 20 to 90 pounds per square inch
(psi).
•
Check water hardness. For extremely hard
water, it may be necessary to install a water
softener. (See Detergent Usage Guide, page
13.)
•
Usefreshdetergent.
•
Make sure items are not blocking any of the
spray arms, preventing them from rotating.
DISPLAY NOT FUNCTIONING
•
Check to see if unit is in the Display Off
Setting. See page 8 to reactivate display.
•
Make sure the rinse aid dispenser is filled.
•
Increase the amount of rinse aid (See Rinse
Aid, page 14).
•
Check the incoming water temperature. Be
sure it is at least 120°F (49°C).
•
Check for proper loading--avoid
nesting
items.
•
Plastic items may need to be towel dried.
More water collects on plastic items when
cycle is complete because they do not get as
hot as glass or metal items.
•
Cups with a concave bottom will collect
water.
DISHWARE CHIPPED
•
Load with care and do not overload. (See
Preparing and Loading Dishes, pages 9-11 .)
•
Place delicate items in top rack.
•
Place glasses securely against pins and not
over pins.
•
Load items so they are secure and don't jar
loose when moving racks in and out. Move
racks in and out slowly.
•
Make sure tall glasses and stemware will
clear top of tub when rack is pushed in.
•
It is recommeded to wash fine antique china
and crystal by hand.
DISPLAY NOT IN OPERATING
MODE
• Hold down SET icon for 5 seconds to reset
unit to Normal Operating Mode.