Using The Features - Greenlee CLM-1000 Manual De Instrucciones

Using the Features

• : Press momentarily to turn the backlight ON. Once
lit, press button again to turn the backlight OFF. The
backlight automatically turns OFF after approximately
30 seconds to extend battery life.
• FT/M: Press momentarily to select length measurement
units. On the LCD, "ft" indicates feet and "m" indicates
meters.
• CAL: The meter must be calibrated each time it is
turned ON. Refer to "Operation" for a complete descrip-
tion of the calibration process.
• Esc: Press to escape from programming process.
• MEM: Button is used for the user-selected program-
ming function. Refer to "Operation" for a complete
description of the programming process.
• Cu/Al: Press momentarily to select cable material.
On the LCD, "Cu" indicates copper and "Al" indicates
aluminum.
Programmable Switch Positions User's Table
Use this table to keep track of the cable size that has been programmed into a switch position.
Make annotations with something erasable because switch positions can be reprogrammed.
Switch
Position
1
2
3
4
5
6
7
8
Gauge
Size
CLM-1000 • CLM-1000E
• HOLD: Press momentarily to enter data hold mode.
When button is pressed, "dH" is present on the LCD and
the current value is captured. To exit this mode, press
the HOLD, FT/M or Cu/Al button. "dH" is no longer
present on the LCD.
• Auto Power Off (APO): When enabled, the meter will
automatically turn OFF after 10 minutes of inactiv-
ity. Inactivity is defined as no button press or rotary
switch movement. The buzzer sounds three times
approximately 30 seconds before the meter turns OFF
as a warning. To disable APO, press and hold the HOLD
button while turning the meter ON.
• qp: Used during the user-selected programming
process. Refer to "Operation" for a complete description
of the programming process.
Type (circle)
mm 2 AWG kcmil aught
mm 2 AWG kcmil aught
2
mm AWG kcmil aught
mm 2 AWG kcmil aught
mm 2 AWG kcmil aught
mm 2 AWG kcmil aught
mm 2 AWG kcmil aught
2
mm AWG kcmil aught
5
Material Type
Cu or Al
Cu or Al
Cu or Al
Cu or Al
Cu or Al
Cu or Al
Cu or Al
Cu or Al