Contact; Appendix; List Of Codes/Faults - DeWalt DS100 Manual De Instrucciones

Contact

If you have any questions or comments about this product, call us toll free at 1-800-4-
D WALT (1-800-433-9258); or visit www.dewalt.com. To answer any specific monitoring
E
questions call D WALT customer service or refer to the monitoring service contract for
E
additional contact phone numbers.
Full One Year Warranty
The D WALT Jobsite Security Portable Alarm System is warranted for one year from date
E
of purchase. We will repair, without charge, any defects due to faulty materials or work-
manship. For warranty repair information, visit www.dewalt.com or call 1-800-4-D
(1-800-433-9258). This warranty does not apply to accessories or damage caused where
repairs have been made or attempted by others. This warranty gives you specific legal
rights and you may have other rights which vary in certain states or provinces.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are
missing, call 1-800-4-D WALT for a free replacement. See the beginning of this manual
E
for a list of warnings on the Base Unit and Key Chain Remote.
Patent Notification
Manufactured under one or more of the following patents.
5,587,701 5,777,551
5,850,180 6,049,273
Other patents may be pending.
LED DISPLAY CODES
LED SOLID
POWER Primary power
source is present
ARMED System is armed
CELL Cellular signal
is strong
CALL Call is complete
(will remain solid
for 30 seconds)
6,441,731
BLINKING OFF
• Primary power supply No unit power
missing (steady flashes); and no battery
• Low battery (series of two power
flashes); or
• Standby state (one flash
every 5 seconds)
On an exit or entry delay System is
disarmed
Cellular signal Little or no
is weak cellular signal
Call is in progress No activity
Fault Code Fault Display
Power Primary Power
Lost Base
DevPower Primary Power Lost
Device #
BaseLowBatt
WALT
E
Low Battery
DevLowBatt Low Battery
Device #
WeakSig Weak Signal
Device #
Unsecured Unsecured
Device #
NoCheckIn No Check In
Device #
Tamper Tamper
BaseBadBatt Bad Battery
CellRadio Cell Radio
Receiver Receiver Fault
Device #
NetControl Base Network
21
DESCRIPTION OF FAULT CODES
Description
No power to
Base Unit
No battery power
in device
Base Base Unit
battery low
Device battery
low
Transmission signal
from device is weak
Device has
been tripped
Device check-in
messages have not
been received
Device has been
opened or damaged
Base Unit battery has
Base dropped below the
voltage limit
Cellular radio
Fault signal is lost
or scrambled
2-way transmission
of device is lost to test system for issues
Base RF processor Internal check; will clear
Control communications itself; call Customer Service
Action
Check power supply
Change battery, reset
Plug in power supply
to recharge battery
Change battery, reset
Check for interference;
move device
Check for intrusion;
re-secure device
Check for interference;
move device
Close device or
replace if damaged
Needs to be repaired
at D WALT authorized
E
service center
Move Base Unit to
a location where
CELL light is solid;
call Customer Service
if problem persists
Call customer service
if problem persists