Alarm Codes - DeWalt DS100 Manual De Instrucciones

ALARM CODES

Display Event
Unsecured device x txt Unsecured
Tampered device x txt Tamper
Unsecured base motion Internal PIR trip
Unsecured base vibration Internal vibration trip
System alarm Start of alarm cycle (8 min.)
ALPHA/NUMERIC CHART
KEY # of presses
PAD 1 2 3 4
1 1 1 1 1
2 2 A B C
3 3 D E F
4 4 G H I
5 5 J K L
6 6 M N O
7 7 P Q R
8 8 T U V
9 9 W X Y
0 0 space . space
NOTE: The subject line of the E-mail/ Text Message identifies the name of the Base Unit either
alarming or under test.
Default E-mail/
Text Msg Notice
Sitelock Event: Auto periodic
test, Sensor # 000
Sitelock Event: Manual
test, Sensor # 080
or # 000
Sitelock Event: Low system
5
battery, Sensor # 000
1
2
3
4
5
Sitelock Event: Burglary
6
alarm open, Sensor # 000
S
8
Z
.
Sitelock Event: Burglary
alarm open, Sensor # XXX
23
CELL PHONE TEXT MESSAGE CODES
Meaning
This is a weekly test
performed between the
DS100 and Sitelock to
assure that the unit and
system are working properly.
Sensor 000 is the Base Unit.
User has performed a
cell radio test. Sensor
# 080 or # 000 indicates
that this is a manual test.
The Base Unit battery
voltage is too low. After
1 hour, the unit will
become disarmed and go
into standby mode.
Unit is armed and an
unauthorized intruder has
been detected by the
Base Unit motion or
vibration sensor.
Unit is armed and an
unauthorized intruder has
been detected by sensor XXX.
Action Required
None. This is a notification
that the system is operating
properly.
None. This is a notification
that the system is operating
properly.
If AC power is not applied,
plug in the unit. If AC power
is applied, the battery is failing
and needs to be replaced
at a D WALT authorized
E
service center.
Contact the police and
provide the appropriate
information to notify them
of an intrusion.
Contact the police and
provide the appropriate
information to notify them
of an intrusion.