Mode Selector Dial - Bosch RHH181 Instrucciones De Funcionamiento

BM 2610028048 12-12_BM 2610028048 12-12.qxp 12/5/12 10:27 AM Page 12
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed Fig. 1).
To reduce the risk of injury
WARNING
immediately discontinue use
of the tool if the variable speed control ceases
to function. Subsequent loss of on/off control
of the trigger switch is likely.
FIG. 9

MODE SELECTOR DIAL

The mode selector dial allows the tool to be
set for various applications as listed in the
following chart, (Fig. 10).
Do not operate the selection
CAUTION
dial until the tool comes to a
Drilling only:
used for drilling
wood, steel, etc.
Operating Instructions
FORWARD/REVERSING LEVER
Drilling/hammering:
used for drilling
concrete
FIG. 10
-12-
FORWARD/REVERSING LEVER &
TRIGGER LOCK
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 9). This lever was designed for
changing rotation of the chuck, and for locking
the trigger in an "OFF" position to help prevent
accidental starts and accidental battery
discharge.
For forward rotation, (with chuck pointed away
from you) move the lever to the far left. For
reverse rotation move the lever to the far right.
To activate trigger lock move lever to the
center off position.
Do not change direction of
CAUTION
rotation until the tool comes
to a complete stop. Shifting during rotation of
the chuck can cause damage to the tool.
& TRIGGER LOCK
complete stop. Shifting during rotation of the
chuck can cause damage to the tool.
When using demolition or chipping bits such
as bull points, chisels, spades, gouges, etc.
the "Hammer Only" mode must be selected.
Vario-lock
allows for desired
positions of "hammer"
Hammering only:
used for light
chipping work