Installation Instruction - CASO DESIGN EMCG 32 Manual De Instrucciones

 This appliance must be electrically grounded. In case of a short circuit grounding will
protect against electric shocks because the electrical current is diverted through the
grounding lead. The appliance is fitted with an appropriate cable with a ground lead and
a grounded safety plug. The plug must be inserted into a properly installed and
grounded outlet.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.
 Adapters, multi-way strips and extension leads must not be used. Overloading can lead
to fire.
 If the plug is no longer accessible following installation an all-pole isolating switch must
be present on the installation side with a contact gap of at least 3mm.
 In accordance with the appropriate regulations, the socket must be installed and the
connecting cable must be replaced only by a qualified electrician.

11.5.3 Installation instruction

 Please observe this special installation instructions.
 The appliance can be installed inside a 60cm wide wall-mounted cupboard (at least
55cm deep and 85cm off the floor).
 The built-in cabinet shall not have a rear wall behind the appliance.
 Do not cover ventilation slots and air intake points.
caso EMCG 32
Do not trap or kink the power cord.
Make sure that the oven is installed in the
center of the cabinet.
30 mm free space is needed above the
device top surface
Open the door; fix the oven to the
cabinet with screw at the installation
hole. Then fix the trim-kit plastic cover
(1) on the screw (2) in the installation
hole (3).
54