11 Commissioning
This chapter provides you with important safety notices during the initial commissioning of
the device. Observe the following notices to avoid dangers and damages:
11.1 Safety information
Personal and property damages can occur during commissioning of the device!
Observe the following safety notices to avoid such dangers:
► Packaging materials may not be used for playing. There is a danger of suffocation.
► Transport, unpack and use two persons to set down the device because of the heavy
weight of the device.
11.2 Delivery scope and transport inspection
As a rule, the EMCG 32 Microwave is delivered with the following components:
EMCG 32 Microwave
Rolling ring
Screw and Trim-kit plastic cover for installation
Operating Instructions
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.
11.3 Unpacking
To unpack the device, proceed as follows:
Remove all packaging and accessories.
Check the appliance for possible damages (dents, damaged door etc.). Damaged
appliances may not be used.
Casing: Remove the protective film covering the outside surface of the appliance.
The light brown/silver cover in the interior of the appliance protects the magnetron and
must not be removed.
11.4 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled.
caso EMCG 32
Warning
Please note
Glass turntable
Grating
52