Erasing Recordings On A Cd-Rw; Erasing All Tracks; Erasing The Last Track - Aiwa XR-MR5 Manual De Instrucciones

ERASING RECORDINGS
ON A CD-RW
You can erase recordings on a CD-RW in the following three ways:
(All these ways are applicable only to a CD-RW. Recordings on a
CD-R cannot be erased in any way.)
All tracks erasing erases all tracks on a CD-RW at one time.
Last track erasing erases only the last track on a CD-RW.
Unfinalization erases the Table Of Contents (TOC) on a finalized
CD-RW.
Through the erasing process, you can restore a CD-RW damaged
by unsuccessful recording or finalizing due to a power interruption
during the process.
NOTE
• Never turn the unit off by pressing POWER or disconnecting
the AC cord during the erasing process.
If the unit is turned off even by accident or power failure damages
the disc and it may no longer be restored.
• During the erasing process, all the buttons (except POWER)
are inoperative.

ERASING ALL TRACKS

All tracks erasing erases all tracks on a CD-RW at one time and it
erases the Table Of Contents (TOC) on a CD-RW as well, if the
CD-RW has been finalized.
After erasing, the CD-RW cannot be played on the CD player of
this unit or any other conventional CD players.
s
ERASE MODE
ENTER/
ILLUMINATION
CD-R/RW
zCD-R/RW
OPEN/CLOSE
1 Load a CD-RW in the CD-R/CD-RW player/recorder.
Load the disc with the label side up. To open or close the disc
tray, press z CD-R/RW OPEN/CLOSE.
2 Press CD-R/RW.
Wait until the unit finishes reading the loaded disc. (Make sure
the "CD-RW" indicator lights up.)
3 In stop mode, press ERASE MODE repeatedly until
"Erase All?" is displayed.
24
ENGLISH
4 Within 10 seconds, press ENTER/ILLUMINATION.
5 Within 1 minute, press ENTER/ILLUMINATION
Last track erasing erases only the last track on a CD-RW.
To erase the last track on a finalized CD-RW disc, unfinalize the
disc first. You cannot erase the last track unless you unfinalize
the disc.
After erasing, the CD-RW cannot be played on the CD player of
this unit or any other conventional CD players. To do so, finalize
the CD-RW.
CD-R/RW
s
ENTER
ERASE MODE
1 Load a CD-RW in the CD-R/CD-RW player/recorder.
2 Press CD-R/RW.
3 In stop mode, press ERASE MODE repeatedly until
Alternatively, press ENTER on the remote control.
"Erase?All?" is displayed.
If you erase all the tracks, you cannot retrieve them again.
Make sure it is all right to erase all the tracks.
To cancel, press s.
again.
Alternatively, press ENTER on the remote control.
"ERASE" appears on the display, the approximate erasing time
is displayed and counts down.
When erasing is completed, "Blank Disc" is displayed.

ERASING THE LAST TRACK

s
ERASE MODE
ENTER/
ILLUMINATION
CD-R/RW
zCD-R/RW
OPEN/CLOSE
Load the disc with the label side up. To open or close the disc
tray, press z CD-R/RW OPEN/CLOSE.
Wait until the unit finishes reading the loaded disc. (Make
sure the "CD-RW" indicator lights up.)
"Erase ?" is displayed.
Example: when the 12th track is the last track
CD-R/RW
s
ENTER
ERASE MODE