Emptying The Dust Cup Assembly - Shark NV22 Manual Del Usuario

Emptying the Dust Cup Assembly

For best results empty the Dust Cup
Assembly after each use; empty several
times during prolonged usage.
Or empty the Dust Cup Assembly when
it reaches the MAX fill line; NEVER
OVER-FILL THE DUST CUP.
Stand vacuum into upright position.
Turn vacuum off.
CAUTION:
Unplug the vacuum;
failure to do so
might result in
electric shock.
1
To empty the Dust Cup Assembly:
1 Grip carry handle and press the
Dust Cup release button to remove
Dust Cup Assembly
2 Option A: for Quick Empty:
Insert Dust Cup Assembly deep
inside trash receptacle to contain
dust and debris.
Press the Dust Cup Door release
button; tap container gently to
dislodge and release dust
and debris.
Snap door in place.
10 TOLL FREE: 1-800-798-7398
Important: if the Dust Cup Door
does not swing open after pressing
the release button, push the door
open using the bottom door tabs.
3 Option B: for Allergy Sufferers:
Wrap a trash bag around the Dust
Cup Assembly leaving space at the
bottom for the door to swing open.
Locate the Dust Cup Door release
button within the trash bag and
press to release as you shake the
dust cup to empty dust and debris.
Snap the bottom door in place.
Note: Some dust and debris may
remain in the top of your dust cup
assembly on or near the metal
screen. It is not necessary to
completely remove this material
before continuing to vacuum;
®
Shark advanced cyclonic action
will sweep the metal screen clean
once you begin to refill your
dust cup.
2
Note: Option B can also be
performed outside of the home to
further minimize releasing dust back
into the air. Carry just the Dust Cup
Assembly and trash bag outside.
3