Hold / Smart Hold; Limit (Alarm) - LEM HEME ISO 1000 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Advanced functions

6.2. HOLD / SMART HOLD

HOLD for the HEME ISO 1000 immediately freezes the displayed
values
SMART HOLD for the HEME ISO 2000 allows hands free
operation by only triggering the HOLD function above a preset
threshold set at approximately 10% of the measuring range.
Activation of SMART HOLD functions: Press the HOLD key and
apply the test leads or the current source to be measured, the
HOLD symbol will flash. Once a measurable signal is present the
instrument beeps and the Hold function becomes active freezing
the display. To reactivate the HOLD function while the
instrument is still connected press the HOLD key again.
Alternatively to reactivate the HOLD disconnect the source being
measured and then reapply the source. The last value to be
measured will be held until a new signal is detected which is
above the default threshold.
To switch the SMART HOLD function off, press the HOLD key for
2 seconds.
The HOLD function operates on whatever parameter is being
displayed in the upper digits block; i.e., one of AC, TRMS or DC.
It is not applicable to insulation measurements

6.3. LIMIT (Alarm)

The limit (alarm) function is activated with the
be used to detect when a value exceeds or falls below user
definable thresholds.
Exceeding the limit values is reported on the display and by
the buzzer (the lower limit with display "<LIMIT" and low
frequency sound, the upper limit with display ">LIMIT" and
high frequency sound).
The limits can be changed by pressing the
"Crossed limits" are supported for testing if a value is within a
certain range. The limit and appropriate >/< symbols are
displayed. They are not flashed. If the upper limit value is
placed below the lower limit value, the measured values
between the two limits are displayed with both annunciators
"<>" on and reported acoustically.
Limit values are displayed in the smaller display when in the
change limit mode. The limit values can be changed using
the
and
turned off completely by pressing the the
activating the limit display – the display shows OFF..
key and can
key again.
arrow keys. The high or low limit can be
key after
- 20 -

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Heme iso 2000

Tabla de contenido