Operating Through Menus - Sony PVM-1353MD Manual De Instrucciones

Operating through Menus

There are five buttons for menu operations on the front
panel of the monitor. To display the main menu, first press
MENU (EXIT). The buttons you can use appear at the
bottom of the menu screen.
Functions of the buttons
RGB/COMPONENT
B A B
RESET
BLUE UNDER OVER
ONLY SCAN SCAN
RESET
button
To select menu
Button
item
MENU return to the
previous menu.
EXIT
decide a
ENTER
selected item.
SELECT
>
move the cursor
+ (z) upwards.
move the cursor
–
(z) downwards.
.
RESET
(The above items in white type correspond to the marks in
the menu.)
SPLIT MENU
AP
E X I T
SELECT
M
ENTER
Buttons for
menu
operations
To adjust selected menu
item
return to the previous
menu.
select an item.
increase selected value.
decrease selected value.
reset current adjustment
value to the factory setting.
The Contents of Menu Items
The following sentences show the details of each menu
items.
[ ] indicates the factory setting position.
1 Main menu
Select an item and press the ENTER (SELECT) button
to go to the following menu.
2 COLOR TEMP SELECT menu
Select the color temperature from among 6500K, 5600K
and USER. USER is set to 6500K in the factory setting.
You can adjust or change the color temperature in
USER mode (a measuring instrument is needed).
Note
The color temperature of the USER mode can be
adjusted in the range from 3200K to 10000K.
You can adjust the color temperature of the USER mode
in the USER COLOR TEMP ADJUST menu (!£) of
the user service mode.
For the details, see "USER COLOR TEMP ADJUST
menu (!£)" on page 10.
3 CAPTION VISION menu
To display closed captions, select ON and the type of
caption you would like.
4 PRESET menu
You can preset each control to a desired level and set it.
If you set PRESET to ON, the REMOTE indicator
lights up and the controls on the front panel do not
work. The monitor operates with the internal memory
settings. For adjustment, select the PRESET ADJUST
screen.
5 CONFIG menu
Select an item for adjustment of the monitor.
6 PRESET ADJUST screen
Adjust CONTRAST, BRIGHT, CHROMA, PHASE,
VOLUME, APERTURE in the PRESET menu.
7 CHROMA SET UP menu
Set to ON to adjust the internal decoder for CHROMA
and PHASE (NTSC signal only) after AUTO ADJUST
screen (!™).
8 RGB A SYSTEM menu
To monitor the signal fed through the RGB/
COMPONENT A connectors, set the RGB or COMP
(component) signal and the INT SYNC (internal sync)
or EXT SYNC (external sync) signal in this menu.
c
[6500K]
[OFF]
[OFF]
[OFF]
[RGB-EXT SYNC]
9