Hilti DEG125-D Manual De Instrucciones página 25

Conductor cross
section
Mains voltage 110-
120 V
Mains voltage 220-
240 V
en Do not use extension cords with 1.25 mm² or 16 AWG conductor cross sections.
2.9 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
2.10 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled: The unit
must provide a power output in watts of at least twice the value printed on the type identification plate on the power
tool. The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in
the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and
starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching other
power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the
power tool.
2.11 Using the Kwik-Lock clamping nut with grinding / cutting discs
The Kwik-Lock nut may be used instead of the standard clamping nut. No tools are then required for changing cutting
discs.
NOTE
The Kwik-Lock nut cannot be used with cup wheels, brushes, rubber backing pads, tuck pointing discs (special discs
used for joint repair) or with diamond cup wheels.
2.12 DG-EX 125/5" dust removal hood for grinding 2
The tool is suitable only for occasional use with diamond cup wheels for grinding mineral materials.
CAUTION
Use of this guard for working on metal is not permissible.
NOTE
It is recommended that a dust removal system consisting of matched components, i.e. dust removal hood and a
suitable Hilti vacuum cleaner, are used for cutting, grinding and slitting work on mineral materials such as concrete or
stone. These serve to protect the operator and increase the life of the tool and disc used.
2.13 DC‑EX 125/5"‑M dust removal hood with guide carriage for cutting and slitting 3
Cutting and slitting work on mineral materials may be carried out only when the power tool is equipped with a dust
removal hood with guide carriage.
CAUTION
Use of this guard for working on metal is not permissible.
NOTE
It is recommended that a dust removal system consisting of matched components, i.e. dust removal hood and a
suitable Hilti vacuum cleaner, are used for cutting, grinding and slitting work on mineral materials such as concrete or
stone. These serve to protect the operator and increase the life of the tool and disc used.
2.14 DC‑EX 125/5"‑C compact dust removal hood for cutting 4
For cutting concrete and masonry.
CAUTION
Use of this guard for working on metal is not permissible.
20
1.5 mm² 2 mm²
20 m 30 m
50 m
2.5 mm² 3.5 mm²
40 m 50 m
100 m
14 AWG 12 AWG
75 ft 125 ft