Warranty - SPARKY K 1640 Instrucciones De Uso

bar wrench. Take care not to lose the rubber sealing at-
tached below the oil gauge. After feeding oil, clamp the
oil gauge securely. Use only SPARKY custom oil, de-
livered with the machine. Shell
(engine oil) can also be used.
If the impact power is reduced you may add 40g of oil. In
case the impact energy is still low, the O-ring of the piston
and/or other related parts must be checked. It is not al-
lowed to add more grease.
inspEctiOns
inspecting the bit
Longer operation life of the demolition hammer and high-
er efficiency can be achieved only with well-sharpened
tools for demolition and chiselling.
Operating with a dull tool will degrade efficiency and may
cause malfunction. When signs of abrasion are noted, it
is necessary to sharpen or replace the toll immediately.
inspecting the fasteners
Regularly inspect all fasteners and ensure they are
properly tightened. Should any of the screws be loose,
retighten it immediately to avoid hazards.
motor maintenance
To prevent motor damage never allow contact of motor
windings with water or oil.
brush replacement
This power tool is equipped with auto-stop brushes.
When the carbon brushes are worn out, the machine
switches itself off.
Both brushes must be replaced after 100-120h of opera-
tion at SPARKY authorised service centre.
cleaning
For safe operation always keep the machine and its ven-
tilation slots (9) clean.
Always clean the ventilation slots and the tool holder af-
ter operation carefully with a dry brush.
Never operate a power tool with clogged ventilation slots.
Exterior plastic parts may be cleaned with a damp cloth
and mild detergent.
WaRning: Although exterior plastic parts are
highly solvent resistant, never use solvents!
impOrtant! To assure product safety and reliability,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by
certified service centres or other qualified service or-
ganisations, always using genuine replacement parts.
Original instructions
Oil Co. ROTELLA #40
®
VIII - Warranty
The guarantee period for SPARKY power tools is deter-
mined in the guarantee card.
Faults due to normal wear, overloading or improper han-
dling will be excluded from the guarantee.
Faults due to defective materials implemented as well as
defects in workmanship will be corrected free of charge
through replacement or repair.
The complaints for defective SPARKY power tools will
be recognized if the machine is sent back to the dealer
or is presented to the authorised warranty service centre
undismantled, in its initial condition.
Notes
Carefully read the entire original instructions before us-
ing this product.
The manufacturer reserves the right to make changes
and improvements to the products and to alter specifica-
tions without prior notice.
Specifications may differ from country to country.
7
EN