Maintenance; Warranty - SPARKY HeavyDuty X 85CES Plus Instrucciones De Uso

ROUTING BIG WORKPIECES
In order to guide the router bit use an auxiliary
board fixed on the machined surface. Guide the
router with both hands, the flat part of the router
base 8 being constantly pressed against the
auxiliary board.
ROUTING WITH SUCTION
Place the adapter in the cradle in base 8, from
its lower side, cylindrical part pointing forward.
Fix the adapter to the base with two screws and
place the transparent cover. The inner diameter
of the adapter for connecting to the vacuum-
cleaner is equal to 30 mm.
ACCESSORIES TO BE USED WITH
THIS POWER TOOL
▪ HSS router bits - Ø6; Ø8
▪ Carbide tipped bits - Ø6; Ø8

Maintenance

WARNING: Always ensure that the
tool is switched off and unplugged before
attempting to perform inspection or mainte-
nance.
BRUSH REPLACEMENT
This power tool is equipped with auto-stop
brushes. When the carbon brushes are worn
out, the machine switches itself off. In this case
both brushes must be replaced simultaneously
with genuine brushes at SPARKY service centre
for warranty and post-warranty service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they are
properly tightened. Should any of the screws be
loose, retighten it immediately to avoid hazards.
If the replacement of the supply cord is neces-
sary, this has to be done by the manufacturer or
his agent in order to avoid a safety hazard.
CLEANING
For safe operation always keep the machine
and its ventilation slots clean.
Regularly check to see if any dust or foreign mat-
ter has entered the ventilation slots and the grills
around the switches. Use a soft brush and/or air
jet to remove any accumulated dust. Wear safety
8
EN
glasses to protect your eyes whilst cleaning.
Maintain threaded sockets clean.
Clean regularly and lubricate periodically verti-
cal guides 12 with oil.
Exterior plastic parts may be cleaned with a
damp cloth and mild detergent if necessary.
WARNING: Never use alcohol, petrol
or other cleaning agent. Never use caustic
agents to clean plastic parts.
WARNING: Water must never come
into contact with the tool.
IMPORTANT! To assure product safety and re-
liability, repairs, maintenance and adjustment
(including brush inspection and replacement)
should be performed by certified service centres
or other qualified service organisations, always
using genuine replacement parts.

Warranty

The guarantee period for SPARKY power tools
is determined in the guarantee card.
Faults due to normal wear, overloading or im-
proper handling will be excluded from the guar-
antee.
Faults due to defective materials implemented
as well as defects in workmanship will be cor-
rected free of charge through replacement or
repair.
The complaints for defective SPARKY power
tools will be recognized if the machine is sent
back to the dealer or is presented to the author-
ised warranty service centre undismantled, in its
initial condition.
Notes
Carefully read the entire Instruction Manual be-
fore using this product.
The manufacturer reserves the right to make
changes and improvements to the products and
to alter specifications without prior notice.
Specifications may differ from country to coun-
try.
X 85CES Plus ● X 110CES Plus