Rear Panel; Problem Cart; Cleaning And Maintenance - Omnitronic DMF-2 Manual Del Usuario

(9) HI FQ CUT-CONTROL
With the Hi FQ Cut-control, you can adjust the output frequency that will be cut off. Turn the control to
the right to increase the frequency and to the left to lower it.
(10) POWER LED
5.2 Rearpanel
(11) AC IN SOCKET
Used to plug the power unit in.
(12) OUT
Output sockets for connecting your power amplifier or mixer Effect Receive-input.
(13) LINE INPUT-SOCKETS
Input socket for line-signals.
(14) PHONO INPUT-SOCKETS
Input socket for turntables.
(15) GND (Ground terminal)
Connect the ground lead of the turntable with this terminal. This helps to reduce humming and pop noises.

6. PROBLEM CART

PROBLEM:
No power. • The power-cord is not connected.
No sound. • The power-cord of the respective device is
not connected properly or not connected at
all.
• The connection-socket or the plug is dirty.
Noise. • The input-signal is too strong.

7. CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
CAUSE:
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
• Check the power-cord and any extension-
cables.
• Check the power-cord and if the plugs are
tightly connected with the sockets.
• Clean the socket and/or the plug.
• Reduce the input-signal via the Input-
control.
12/23
REMEDY:
10453030_V_1_0_7871.DOC