Connections; Description Of The Device; Front Panel - Omnitronic DMF-2 Manual Del Usuario

Never use spray cleaners in order to clean the faders!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

4. CONNECTIONS

• Install the device on a plane surface.
• Before you connect the devices, all units have to be switched off.
• In order to obtain highest sound quality, only use high-quality cables for connecting the devices. Make sure
that the cables are properly fixed.
• Connect the connection cable of the power-unit with the AC IN-socket. Plug the power unit into your outlet.

5. DESCRIPTION OF THE DEVICE

5.1 Frontpanel
(1) LOW FQ CUT-CONTROL
With the Low FQ Cut-control, you can adjust the output frequency that will be cut off. Turn the control to
the right to increase the frequency and to the left to lower it.
(2) RES.LOW-CONTROL
With the RES.LOW-control, you can adjust the resonance for the Low FQ Cut.
(3) BAND/NOTCH-SWITCH
In the Notch-position, you can listen to the sound filtered by the Low FQ Cut and Resonance Low.
(4) PHONO-SWITCH
Press this switch when transforming the Phono-inputs.
(5) INPUT-CONTROL
With the Input-control, you can adjust the signal level of the input signal.
(6) TRIGGER-BUTTON
With the Trigger-button, you can temporarily overrun the Bypass-switch.
(7) BYPASS-SWITCH
With the Bypass-switch you can deactivate the filter-function.
(8) RES.HI-CONTROL
With the RES.HI-control, you can adjust the resonance for the Hi FQ Cut.
11/23 10453030_V_1_0_7871.DOC