Fitting Accessories; Fitting And Adjusting The Shock Absorber; Fitting The Kit For Stroke Length Adjustment - Aventics GPC Serie Instrucciones De Servicio

50 AVENTICS | GPC | R402003957–BDL–001–AB
Installation
6.2

Fitting accessories

Accessories can be ordered separately and are then supplied
unfitted.

6.2.1 Fitting and adjusting the shock absorber

Shock absorber is always included with the GPC-ST (2 pcs) and
with the GPC-E (1 pc).
1. Screw the shock absorber (1) into the corresponding hole.
2. Screw the locking nut (2) onto the outer side of the shock
absorber.
3. Adjust the position of the shock absorber, if necessary, and
lock the position by tightening the locking nut. Torque 6 Nm.
1
2
Abb. 7: Fitting the shock absorber

6.2.2 Fitting the kit for stroke length adjustment

The kit for stroke length adjustment can be fitted onto the GPC-E
for adjustment of the stroke length also for the return stroke.
The kit includes a shock absorber and all mounting details.
1. Fit the two guide pins (1) in the corresponding holes on the side
of the cylinder.
2. Fit the holder (2) with the larger screw (3) according to the
figure.
3. Fit the counterstay (4) on the side of the front plate (6) with the
two smaller screws (5).
4. Screw the shock absorber (7) into the holder and then screw
the locking nut (8) onto the shock absorber.
00129066