Oregon Scientific OS6976 Manual De Usuario página 13

NOTE: If your cabinet has glue blocks or other obstructions, cut out corresponding areas
on the template to clear them. Do not cut out or cut through the screw holes in the
template.
CAUTION: We recommend safety glasses be worn while drilling screw holes to
prevent the possibility of eye injury.
2. Drill four 1/4" diameter holes through the underside of the cabinet.
TIP: On wooden cabinets you may want to mark and start the drill holes with a nail or an
awl. Be sure to hold the drill very firmly against the cabinet.
Use masking tape above the hole locations on the inside of the cabinet shelf to reduce
splintering. If installing the unit under a wood cabinet, you may want to countersink the drilled
hole from the INSIDE of the cabinet. This will eliminate the use of washers and allow the screw
head to be flush with the floor of your cabinet. If you cannot countersink the holes, use the
supplied washers.
3. Remove the template and drill shavings from inside and underneath the cabinet.
4. If your cabinet does NOT have an overhang, go to Step 5.
If your cabinet HAS an overhang, select the spacer or combination of spacers, that is equal to
the length of the overhang, plus 5/8". The added 5/8" is to insure adequate space to remove the
handset.
Length of
overhang
plus 5/8"
Clearance required for
handset access
Unit as correctly
positioned
os6976-en1.p65
Cabinet
overhang
5/8
13
Washer
Cabinet bottom
Spacers
3/8" Minimum
2-1/16"
Maximum
Select screws that meet
minimum but do not exceed
maximum length
5/20/2005, 12:09 PM
10