MTD Shift-On-The-Go 760 Manual Del Operador página 10

the
seat is engaged in
the seat s top; stand
behind t he machine
and back on seat
until fully engaged
into stopl
i
NOTE: Forshipping rea-
sons seats are either
fastenedtothe tractor
seat's pivot bracket with
a plastiC tie,or mounted
backward tothe pivot
bracketl either case;
freethe seat form its
shipping position and
applicable instructions
Figure 3-5
Figure 3-6
Figure 3-7
Attaching The Seat
Seatstyles vary bytractormodeland thereare three
differentstyles available:
StandardAdjustment
• QuickAdjustment&
• KnobAdjustment
If the seatfor yourtractorwas notattachedat the factory,
referto Fig. 3-5, Fig. 3-6, and Fig. 3-7 to identifyyour
tractor'sseatstyle and followthe applicableinstructions
belowto attachit.
NOTE:Forshippingreasons,seatsare eitherfastened
to the tractorseat'spivot bracketwith a plastictie, or
mountedbackwardto the pivot bracket.Ineithercase,
freethe seat form its shippingpositionand removethe
two hex screws(or knobs,on modelsso equipped)from
the bottomd seatbeforeproceedingwith applicable
instructionsbelow.
Standard Adjustment Seat
1. Positionthe shoulderscrews(foundon the based the
seat) insidetheslot openingsin the seat pivot bracket.
Fig. 3-5.
2. Slide the seatslightlyrearwardin the seat pivot
bracket,liningup the rearslots in the pivot bracket
with the remainingtwo holesin the seat'sbase.
3. Selectdesiredpositionforthe seat,and securewith
the two hex screwsremoved earlier.See Fig.3-5.
Quick Adjustment Seat
NOTE:ifyour seatwas shippedmountedbackwardson
the seat pivotbracket,pull outthe tab foundon the seat
stop and hold itopen whileslidingthe seatoff the seat
pivot bracket.See Fig. 3-6.
1. Line up the plasticseat spacerswith the slotsin seat
pivot bracket.
2. Slide seat in untilfront seat spacerengagesthe seat
stop.See Fig. 3-6.
bi_ make surestop,WARNINGstand behindthe machine and pull :theseat is engaged in the Bef°re operating thismachine,seat
back on seat until fully engaged into stop.
Knob Adjustment Seat
1. Positionthe shoulderscrews(foundon the based the
seat) insidetheslot openingsin the seat pivot bracket.
Fig. 3-7.
2. Slide the seatslightlyrearwardin the seat pivot
bracket,liningup the rearslots in the pivot bracket
with the remainingtwo holesin the seat'sbase.
3. Selectdesiredpositionforthe seat,and securewith
the two knobs removed earlier.See Fig.3-7.
10