MTD Shift-On-The-Go 760 Manual Del Operador página 26

Ocultar thumbs Ver también para Shift-On-The-Go 760:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
Be sure to shut the
engine off, remove
ignition key, d iscon-
nect the spark plug
wire(s) and ground
against the engine to
prevent unintended
starting before remov=
ing the belt.
Avoid the possibility of
a pinching injury. Do
not place your fingers
on the idler spring or
between the belt and a
pulley while removing
the belt.
Changing
the Deck Belt
WARNING:Be sure to shut the engine
off,removeignition key,disconnect the
spark plug wire(s) and ground against
the engine to prevent unintended starting
before removing the belt.
All belton yourtractorare subjectto wearand shouldbe
replacedif any signsof wearare present.
IMPORTANT: T heV-beltfoundon yourtractorare
speciallydesignedto engageand disengagesafely.A
substitute(non-OEM)V-beltcan be dangerousby not
disengagingcompletely.Fora properworkingmachine,
usefactory approvedbelts.
Tochangeor replacethe deck belt on yourtractor,
proceedas follows:
1. Lowerthe deck by movingthe deck lift leverintothe
bottomnotchon the rightfender.
2. Removethe beltguardsby removingthe self-tapping
screwsthat fastenthem to the deck.
.
4.
Removethe beltkeeperrodfrom aroundthe engine
pulley.
On the 42-inchdeck only, loosenbut do not remove,
the idler pulleynuts.This will enablethe belt to be
easily removed from the idler pulleys.See Fig. 6-7 on
the previouspage.
_1=
ARNING:Avoid the possibilityofa pinch-
ing injury. Do not place your fingers on the
idler spring or between the belt and a pulley
while removing the belt.
5. Removethedeck belt fromaroundall pulleys,including
the deck idler pulley.
6. Routethe newbelt as shownin and Fig.6-8, 6-9 or
6-10.
7. Remountthe beltguardsremovedearlier.
Changing
the Lower Deck Belt (46" Decks)
NOTE:Severalcomponents mustbe removedin orderto
changethe tractor'slowerdeck belt. Seean authorized
MTDService Dealerto haveyourlowerdrivebelt replaced
or phoneCustomerSupportas instructedon page2 for
information on orderinga ServiceManual.
Changing
the Transmission
Drive Belt
NOTE:Severalcomponents mustbe removedand special
tools (i.e.air/impactwrench)in orderto changethe
tractor'sdrive belt. Seean authorizedMTDServiceDealer
to haveyourdrivebelt replacedor phoneCustomerSup-
portas instructedon page 2 for informationon orderinga
ServiceManual.
f
Idler Bracket
Engine Pulley
\
38-Inch Deck
©
o
b
Deck Idler Pulley
Figure 6=8
26

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Shift-on-the-go 77913ac762f755

Tabla de contenido