Usage - Warning; Unit Power Supply; Thermostat Adjustment - Quick BX 16 Manual Del Usuario

WARNING: follow the instructions of the boat engine manufacturer on how to connect engine cooling
liquid to the heat exchanger.
• Fit the stub pipe (11) to the valve (9) using the hose clamp.
Fit the pipe so as to allow any possible water leak not to cause damage to part of the boat.
• Open up hot water taps of the washbasins and start the water pump.
This allows water to fi ll the water heater and force air out of water heater and pipes.
Close taps as soon as air free water comes out.
• Check that there are no leaks on pipe joints.

UNIT POWER SUPPLY

See fi g.3 for the connection. Make sure the water heater operating voltage is the same as that provided by AC
network.
A double pole switch has to be included on the electric installation, in order to turn on and off the unit, as well
as a fuse of suitable rating. The insulation between connections contacts of the AC network must be at least
3 mm. The connections to AC network must be done following the National Specifi cations on electrical instal-
lations.
WARNING: before carrying out the connection make sure the cables are not live.
WARNING: don't operate the electric element if the tank is not fi lled with water. It may cause a perma-
nent damage to the electric element.

THERMOSTAT ADJUSTMENT

The standard temperature value of the thermostat is 60°C. If you wish to change it, follow the instructions
below:
• shut down power supply.
• Remove the protection cover (16) in order to reach the thermostat (14).
• Adjust the thermostat knob with a screwdriver (fi g. 4) and turn it to the required temperature.
• Replace on the protection cover (16).
• Switch on power supply.
F
The mixer controls the hot water temperature when the heating elements and the heat exchanger are
used.
BOILER BX16 - REV006A
(In models provided)
(in models provided)

USAGE - WARNING

GB
13