SFS isoweld 3000 Instrucciones De Operación página 20

Ocultar thumbs Ver también para isoweld 3000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Start-up
Before working with the induction welding tool, the project parameters must
be entered into the display. The parameters required are the waterproof
membrane material and thickness. The following options are available:
Note: the settings (parameters) used last will be loaded. It is possible to
either adopt these settings or make new selections of the following settings.
Waterproof
membrane
material
PVC
0.9-1.1/35-44 1.2-1.4/45-59 1.5-1.7/60-69 1.8-2.0/70-79 2.1-2.3/80-90
TPO
Display examples
For changing the settings, proceed as follows:
The position display is on the choice of the waterproof membrane material
( first line).
1. Press the button
2. Press the
L
membrane material is displayed.
3. Confirm the selection by pressing the
M
4. Press the
5. Press the
OK
6. Press the
L
7 . Confirm the selection by pressing the
The parameters have now been set and stored.
20
Waterproof membrane thickness (mm/mil)
OK
. ≥ appears and flashes.
button or press the
button to go to the waterproof membrane thickness selection.
button. ≥ appears and flashes.
or
button to determine the waterproof membrane thickness.
M
button until the required waterproof
M
button.
OK
button.
OK
appears.

Publicidad

Capítulos

Tabla de contenido
loading

Productos relacionados para SFS isoweld 3000

Este manual también es adecuado para:

Isoweld backpack

Tabla de contenido