SFS isoweld 3000 Instrucciones De Operación página 32

Instructions for isoweld
Parts needed:
Description
isoweld backpack tool
®
Replacement Generator
Tools needed:
• T20 TORX
• bit driver extension (included)
• screw gun or bit driver
- small flathead screwdriver
Step 1: Generator removal
Before starting ensure the tool is not plugged in and that the hand inductor/wired
switch plugs are not installed in the bottom of the generator. Loosen the gland
nut for the power cord (left).There are 4 screws (right) holding the grey shell onto
the frame. Remove these with the T20 TORX
off.
In order to remove the generator from the frame the orange shell must be pulled
up slightly for clearance. The orange shell is located on the frame by 4 studs
which are also the threads for the screw that held the grey shell on. The shell
needs to come off these studs before it can be slid up. To do this, push against
the frame while pulling the shell in the direction shown (left). Do this for all 4
studs (two on each side).
backpack generator hot swap
®
bit (included)
®
Quantity
1
1
® bit then pull the grey shell straight