Disposal; Maintenance, Service And Warranty - SFS isoweld 3000 Instrucciones De Operación

Disposal

The tool must not be disposed of with household refuse.
Dispose of the tool at the disposal points provided for this type of
equipment in accordance with the national or local regulations.
The tool must be disposed of in accordance with the European
Directive 2012/19/EU (WEEE). This directive regulates the return and
recycling of waste equipment within the EU.

Maintenance, service and warranty

NOTI CE
USE ONLY SFS MARKED PLATES
Welding with plates without an SFS
stamp may result in roof assembly failure.
• Regularly clean the tool using a soft cloth and mild cleansing solution.
• Protect the tool from moisture and dirt.
WARNING!
Avoid contact between any plastic components of this equipment and
solvents, oils, gasoline, petro-based products, acids or other harsh
chemicals; they can damage the plastic components, which could result in
personal injury.
Electrical maintenance
On principle, electrical equipment may only be serviced and repaired by qualified
technicians.
Backpack Straps
If there is damage or wear to the straps or connection points, the strap or
connection may break during use and the machine may fall causing personal
injury.
If the straps are determined to be worn but the connection points show no signs
of wear or damage, remove the straps by removing the eight (8) T25 attachment
screws and loosening the upper tie straps. Replace the straps by reinserting the
eight (8) T25 screws through a new strap and re-attaching the upper tie straps to
the equipment. Use only straps intended for use with this equipment.
Upper tie
straps
28
(4) T25
(4) T25