SFS isoweld 3000 Instrucciones De Operación página 24

1. Preparing the magnet.
2. Place inductor (1) on stress plate.
3. Press the start button on the handle (3).
a. If the unit has been placed correctly, which means that the cover is suffi-
cient, a continuous signal sound will be heard (1 second) and the status
display
M
b. If the unit is not correctly placed, i.e. the cover is insufficient, the inductor
(1) has to be moved until the position is correct (see Fig.1). As soon as the
position is correct, the welding process starts automatically.
c. The tool is equipped with an acoustic search mode which helps the user
to position the inductor precisely on the stress plate. The search mode is
active for max. 15 seconds. When the time limit has
been exceeded, a failure signal sound can be heard
(2 seconds). In this case, acknowledge the signal
by pressing the
cool down and restart the welding process (step 1
and subsequent steps).
Operation: welding
4. The welding process takes approx. 3 to 4 seconds and is terminated
with a double signal sound.
Caution: moving the tool before the welding process has been
completed will always result in an error message and a faulty weld!
5. After completing the welding process, move the tool from the weld
and immediately place a magnet on the welded point. Allow the
magnet to remain for at least 1 minute. The magnet ensures the
necessary pressure and cooling of the stress plate. It is an essential
part of achieving a good weld!
The magnet must be placed within the first 3 seconds after
terminating the welding.
Check the underside of the magnet regularly and remove any metallic
particles.
The magnet must not be rotated during or after positioning if there is
contact with the waterproof membrane. If this instruction is not followed,
the waterproof membrane may be damaged.
6. Move to the next plate position and repeat the search and welding process as
described in steps 1 to 5.
7 . At the end of the welding work, switch off the tool at the main switch and
then disconnect from the mains.
Overlaps of waterproof membrane in the area of the stress plate should be
avoided. However, should this situation arise the special function of the welding
tool can be used. Instead of proceeding with normal welding, the
can be pressed. Now proceed as steps 1 to 5.
Important: the
Full overlap
24
changes to orange. The welding process will start automatically.
button, allow the stress plate to
OK
function will only remain active for one weld.
x2
Partial overlap

Fig. 1
function key
x2
Partial overlap